Different Sensory Drivers in Cats and Dogs


Cats and dogs perceive and evaluate food differently, with important implications for palatant design.

Dogs rely predominantly on olfaction when selecting food. This is reflected in two-bowl preference tests, where first choice and intake ratio are strongly correlated (R² ≈ 0.9). In other words, the food selected first is generally consumed in greater proportion, highlighting the importance of aroma in canine feeding behavior.

In cats, this relationship is weaker (typically R² < 0.7), suggesting a greater contribution of post-ingestive sensory perception, including taste. Cats also typically consume kibbles individually, allowing more thorough evaluation of each piece.

Texture and moisture further influence feline acceptance. Dry cat food is typically produced at a final moisture content of 4-6%, supporting the dry texture cats are adapted to.



Dry Vs. Liquid Palatants in Cats


Because taste plays an important role in feline food acceptance, dry palatants can be particularly effective in dry cat food. Applied to the kibble surface, they dissolve in saliva during mastication, promoting direct delivery of palatant compounds to taste receptors.

Liquid palatants can contribute strongly to aroma perception. They also increase final kibble moisture, negatively affecting texture and palatability if drying conditions are not adjusted. Dry palatants typically have a moisture content closer to that of the kibble and have almost no impact on final moisture.

To investigate the impact of palatant format, two-bowl tests were conducted with 30 cats over two consecutive days. In the first series, a super-premium (SP) liquid cat palatability enhancer (LCPE), applied topically at 2.0%, was compared with an SP dry cat palatability enhancer (DCPE) applied at 1.0% or 1.5%. DCPE significantly outperformed LCPE at both application levels (p < 0.001; Figure 1).
  

Figure 1. Cat palatability comparison between 2.0% SP LCPE and SP DCPE applied at 1.0% or 1.5%. DCPE significantly outperformed LCPE at both application levels (Significance: * p < 0.05; ** p < 0.01; *** p < 0.001; NS, p > 0.05.)


However, the comparison was biased by moisture: 2.0% LCPE increased kibble moisture by approximately 1.3 percentage points, whereas DCPE had little impact. Because higher moisture reduces cat palatability, the comparison was repeated under moisture-matched conditions.

As shown in Figure 2, the palatability gap was substantially reduced. At 1.0% DCPE, there was no longer a significant difference versus 2.0% LCPE. At 1.5% DCPE, DCPE remained significantly better, although the gap decreased from 60 to 34 percentage points and significance decreased from p < 0.001 to p < 0.01.
  

800x120

Figure 2. Cat palatability comparison between 2.0% SP LCPE and SP DCPE at 1.0% or 1.5% under moisture-matched conditions.


The effect is palatant-dependent. Under the same moisture-matched conditions, standard (std) DCPE still significantly outperformed std LCPE, even at 1.0% DCPE (Figure 3).
 

Figure 3. Cat palatability comparison between 2.0% std LCPE and std DCPE at 1.0% or 1.5% under moisture-matched conditions.


Combining Dry and Liquid Palatants
DCPE can outperform LCPE at lower application levels. Can combining both formats provide an additional advantage? 

To investigate this, 2.0% SP LCPE + 1.5% SP DCPE was compared with 2.1% SP DCPE alone. Application levels were selected to provide equivalent cost-in-use, and moisture was matched between treatments.

As shown in Figure 4, both treatments achieved similar palatability. Thus, at equivalent cost-in-use, combining liquid and dry palatants can maintain performance while providing greater flexibility.
 


Figure 4. Cat palatability comparison between 2.0% SP LCPE + 1.5% SP DCPE and 2.1% SP DCPE alone at equivalent cost-in-use and matched moisture conditions.


This combination can be particularly useful when:

  • the practical inclusion limit of DCPE has been reached (generally around 3%, above which powder adhesion can become problematic);
  • low-fat coating conditions limit DCPE adhesion;
  • additional liquid palatant is needed to overcome coating constraints while maintaining or increasing performance.

 

Conclusion


Cats and dogs respond to different sensory drivers when selecting and consuming food. Taste and post-ingestive evaluation appear to play a greater role in cats, helping explain why dry palatants can outperform liquid-only solutions in dry cat food.

However, performance depends on the palatant, kibble and coating conditions. Palatant strategies should therefore be validated under customer-specific conditions whenever possible.

Liquid palatants are valuable when formulation or coating constraints limit further dry palatant application. Depending on the palatant and conditions, liquid palatants alone can sometimes match dry palatants, while combining dry and liquid formats can maintain or enhance palatability, with the potential for cost-neutral performance.

Moisture should always be controlled when comparing palatant formats. Both pilot and commercial conditions should be adjusted to maintain the target final moisture and avoid moisture-related bias in palatability testing.


By Science & Technology, AFB International
Source:
All Pet Food Magazine


Rate the reading


About the company

portada empresa

About the company

WHAT WE DO

At AFB International, we develop and produce a full range of liquid and dry palatability enhancers. We use high-quality ingredients proven to optimize companion animal response and consumption.

Our specialty? Meeting your unique needs with custom support. Our worldwide staff of technical experts is ready to assist you with all aspects of palatability enhancement, from product development and testing to processing, logistics and more.

 

HOW WE WORK

Our successful customer relationships are built on clear, consistent communication—starting with really listening to understand your needs so we can respond quickly and effectively. And we keep listening. AFB scientists and technical service managers routinely travel to customer facilities to clearly understand the challenges at hand and the systems in place. Then we can recommend the best viable solutions.

 

OUR TEAM

AFB is dedicated to improving the health and wellness of companion animals worldwide through superior products and services. Our diverse, committed team works collaboratively to serve our clients. Get to know us—and let us know how we can help you!

 

HISTORY

AFB launched in 1986 and has grown to be the global science and technology leader in pet food palatability. Headquartered in St. Charles, Missouri, USA, AFB is a global company with state-of-the-art facilities in the United States, Argentina, Brazil, Mexico, the Netherlands, China, Australia, and Thailand. AFB is a wholly owned subsidiary of Ensign-Bickford Industries, Inc., a privately held, family-owned, professionally managed technical business that traces its roots back more than 185 years.


Videos